The two screw sizes of the camera screw are different. Can you produce them?

For different industries, products, the use of screws in the above is almost a must. Screws are also required on the camera, and there are many types of screws. Earlier, an American customer asked Shi Shi Tong if it could produce camera screw.

The customer said that the two screw sizes of his camera screw were different. One thread specification is 1/4-20 “, the other thread specification is 3/8-20 “, there is a knurled one in the middle, knurled diameter is 15mm, ask if we can produce.

At the same time, the customer also requires that the length tolerance of the camera screw should be very small, because the customer said that if the screw thread is too long, he will not completely screw in one piece during the assembly, which is a little troublesome for him, so he hopes that we can control the tolerance of this length, so as not to exceed the tolerance.

This requirement of the customer can be achieved by Shi Shi Tong, because it is completed by turning, so the tolerance can be controlled at ±0.05mm, while the tolerance required by the customer is not so small, which can be achieved.

If you need camera screw, please contact Shi Shi Tong, Shi Shi Tong can customize the production for you, contact Shi Shi Tong:annie.li@szsst88.com

Skype: kalyn qin M: +86 18124507113 Tel: +86 0755-85296744 Email: annie.li@szsst88.com Add: No. 11, Dinghou Road, Dongfang Community, Songgang Street, Baoan District, Shenzhen, Guangdong, China