Can special screw not open mold?

Last week, Mr. Peng found Shi Shi Tong and told them that he needed a special screw, and sent the drawing of the screw to Shi Shi Tong, asking if we could do it? If so, do we need to open the mold?

After seeing Mr. Peng’s drawings, Miss Song said that this special screw needs to be mould-opened. Mr. Peng asked us if there was any method without mold opening, such as CNC. Because he thinks the mold is very expensive. If this screw of Mr. Peng does not open the mold, then CNC is needed. However, The size of the head is a little smaller than That of Mr. Peng, so Miss Song asked Mr. Peng if he could accept the size of our existing mold.

After looking at the existing mold size of Shi Shi Tong, Mr. Peng said that he could not use this size, and the head was a little small, so the lock would not be tight. Later, After asking Mr. Peng about the quantity of subsequent demand, Ms. Song quoted him the price of mold opening and the price of CNC production.

After careful comparison of the prices of the two production processes, Mr. Peng found that WHEN the quantity was not large in the early stage, CNC would be cheaper, but when the quantity came up later, the price of mould opening would be cheaper. After comparison, Mr. Peng also learned that he would return the mould cost to him after he made enough quantity. Later, Mr. Peng chose to open mold production when placing orders for special screw.

Skype: kalyn qin M: +86 18124507113 Tel: +86 0755-85296744 annie@szsst88.com Add: No. 11, Dinghou Road, Dongfang Community, Songgang Street, Baoan District, Shenzhen, Guangdong, China