Can stainless steel flat socket cap screw be made into machine wire with pointed tail?

Mr. Xu’s company developed a new product some time ago, so it needed to order a new screw. The engineer gave this stainless steel flat socket cap screw a threaded design with a machine-threaded tail. Mr. Xu had asked a screw manufacturer to produce this new screw for him, but the screw tails they produced did not meet his requirements. After several samples were taken back and forth, they were always unqualified. Later, Mr. Xu found the supplier again and found the Shi Shi Tong screw manufacturer, and he asked us if we can make the screw with the end of the machine wire?

According to Mr. Xu’s drawings, Ms. Song told Mr. Xu that this stainless steel flat socket cap screw can be made, but the end of the screw needs to be opened with a pair of rolling thread plates, and the loss of the rolling thread plates will be relatively large. Because Mr. Xu requires that the tip of the thread is pointed, if the rolling thread plate is used too much, his tip will not be so sharp. And Mr. Xu also needs to know this loss in production.

Mr. Xu told Ms. Song that he would pay for the changed mold cost, but he only required that the thread tail of the stainless steel flat socket cap screw be the shape he requested, and he needed samples to confirm before the formal production. After the preliminary proofing and Mr. Xu also confirmed the appearance of the sample, when the order was formally placed, Mr. Xu said that the appearance of the mass production should be the same as the sample.