How do SST control the quality of the phillips pan head self tapping screw?

A customer in the United States gave us an order, which is a phillips pan head self tapping screw and a carbon steel black zinc plated.

At the time of producing the customer’s phillips pan head self tapping screw, Shi Shi Tong did it twice in the beginning. Mainly because the first part of the screw head is not at the same center. At the time of the first inspection, no problems were found. At the second inspection, we found this problem and we immediately stopped production. It turned out that during the production process, the position of the mold was slightly deviated, resulting in the head and the rod not being in the same center.

Then we made adjustments. In the second production, we checked the problem every 10 minutes basically, and it was completed until the beginning, and there was no problem. After the phillips pan head self tapping screw is finished, we start rolling thread. At the time of rolling the thread, we finished the test twice before the start, and the size was no problem, and there was no problem. It was completed smoothly.

After the phillips pan head self tapping screw plating was completed, we checked whether the size after plating was within the tolerance range and whether the surface of the plating was flawed, and found no problem. After that, some screws are taken out for measurement, and the measured picture, the courier number, and the packaged picture are sent to the customer, indicating that the size of the screw is within the tolerance range, and the checked screw has been sent. Let customers pay attention to check.

If you want to customize phillips pan head self tapping screw, please send an email: annie.li@szsst88.com