Custom Metric Oval Head Machine Screws Are Easy? No Technical Content?

Alex is responsible for purchasing electrical products in Hong Kong. The metric oval head machine screws that was previously required to be customized is an outsourced trading company. This can improve your work efficiency.

However, Alex has been very uncomfortable for a while, and the metric oval head machine screws that were purchased are not up to standard. There are various problems in the use, not the diameter of the thread is small, the lock is not tight, and the tolerance of some parts is not right, and some are still broken.

The trading company that cooperated with Alex said that there was no problem at all, saying that there is no technical content and it is easy to do. Although it was repeated several times, it still did not solve. The feedback from the production department made Alex very annoyed. Finally, Alex went to the production factory himself, but the news was not very good. It was not that the quantity was too small to be done, that is to say the metric oval head machine screws are difficult and can’t be done.

I don’t know if Alex found a few factories and finally found our Shi Shi Tong. Shi Shi Tong also encountered difficulties in the production of metric oval head machine screws, and the needles were broken by almost seven. The groove type could not be washed out, and the material was hard. A heater was used for the production, and after a few screws were made, the needle was broken again. Finally, step-by-step processing was adopted to successfully produce.

If you want to customize metric oval head machine screws, please send an email: annie.li@szsst88.com