Ultra low head cross screws stainless steel under what circumstances need to open mold?

For customers customizing screws, it is best not to open the mold. After all, the cost of opening a mold is not cheap. So ultra low head cross screws stainless steel in what case need to open the mold?

First, when the ultra low head cross screws stainless steel are thread forming screws, customers should open the mold. Unless the screw factory just happens to have thread rolling die, otherwise, you should spend money to open mold.

Two, the screws are set into shoulder screws. If the number is relatively small, it can generally be completed by the process of a single die and then turning, because it will be more cost-effective. However, if there are many screws, it is more economical to use cold heading.

Three, there are anti-slip serrations under screws’ heads. The number of anti-slip serrations is different, it is produced according to the needs of customers. If the manufacturer has the same mold, there is no need to open it, otherwise, you should open the mold.

Fourth, the logo is designed above the head of screws. A large number of ultra low head cross screws stainless steel can be produced by opening the mold. And a small number of screws you can make a fine carving.

Five, the forming range of screws’ heads is over standard.

In addition to these circumstances that lead ultra low head cross screws stainless steel to open mold, there are other reasons. Welcome to contact Shi Shi Tong screw manufacturer for more information about screws.

Skype: kalyn qin M: +86 18818786322 Tel: +86 0755-27322278 annie@szsst88.com Add: No. 11, Dinghou Road, Dongfang Community, Songgang Street, Baoan District, Shenzhen, Guangdong, China